I just picked up a 1995 Ram 2500 with a 3" body lift and am getting ready to attack the KDP and a couple other minor issues on the truck and just noticed while disassembling the front of the engine the lower intercooler boots are kinked hard due to the body lift. Whoever orginally put it in never apparently anticipated this, along with the length of the battery cables. I'm assuming I just need longer connector tubes. What would I make them out of, and do I just bead roll the ends, and is it that simple, or is there something else I should know about?
-
TDR Magazine subscribers receive more than the magazine! You also gain additional forum privileges!
Details here: TDR Privileges
Subscribe to TDR Magazine here: https://www.tdr-online.com/
Engine/Transmission (1994 - 1998) Body Lift Issues
- Thread starter Jong
- Start Date
Attention: TDR Forum Junkies To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.
Thanks, TDR Staff
Issue 128 – Digital Version
Digital Magazines
FREE!
TDR Test Drive - Digital Edition
Renew
Subscribe
Gift Subscriptions
Back Issues
Subscription Status
Address Change Form
Buyer's Guides
Ram Diagnostic Trouble Codes
The Perfect Collection
The Perfect Collection Vol. II
TSB Updates
Dodge/Cummins Historical Overview
Cameron Collection
What Makes Us Tick?
Product Showcase
Advertising
Turbo Diesel Register
Issue 128 – Digital Version
Digital Magazines
FREE!
TDR Test Drive - Digital Edition
Renew
Subscribe
Gift Subscriptions
Back Issues
Subscription Status
Address Change Form
Buyer's Guides
Ram Diagnostic Trouble Codes
The Perfect Collection
The Perfect Collection Vol. II
TSB Updates
Dodge/Cummins Historical Overview
Cameron Collection
What Makes Us Tick?
Product Showcase
Advertising
