Here I am

Engine/Transmission (1998.5 - 2002) Boost gauge...HELP!!!

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1998.5 - 2002) coughing white smoke on start-up

Engine/Transmission (1994 - 1998) 4 Dead KDP"S

Status
Not open for further replies.

jzenk

TDR MEMBER
Time to install the boost gauge on my '01. What happened to the predrilled/tapped hole on the manifold to screw the fitting into? Am I missing it or was it deleted? Thanx!
 
Manifold

For the turbo boost gauage there is a 3/4 inch plug on the drivers side of the engine just to the front of the MAP sensor. Its btw the MAP and the fuel filter housing. It has a recesses square drive head. That is where I picked my readings up from. U have to make a fitting from pipe bushings for the boost sensor to fit. I went with a 3/4"male to 1/2"female. Then a 1/2"male to a 1/8"female for my fitting. Hope this helps. BTW dont use the one between the MAP and the IAT, I think that one has coolant behind it.



J-
 
Re: Manifold

Originally posted by JCyrbok

For the turbo boost gauage there is a 3/4 inch plug on the drivers side of the engine just to the front of the MAP sensor. Its btw the MAP and the fuel filter housing. It has a recesses square drive head. That is where I picked my readings up from. U have to make a fitting from pipe bushings for the boost sensor to fit. I went with a 3/4"male to 1/2"female. Then a 1/2"male to a 1/8"female for my fitting. Hope this helps. BTW dont use the one between the MAP and the IAT, I think that one has coolant behind it.



J-
Thanks for the help... I've got it located. Thought I was losin' it there for a second. I appreciate your help. Thanx again!!!
 
Status
Not open for further replies.
Back
Top