Attention: TDR Forum Junkies 
I'm thinking about using the boost/MAP sensor for a 24-valve on my old 1st gen, as an input to a controller I'm building. I don't have a sensor or 24-valve truck to look at 
so I thought I'd ask here.
Where does it mount on the engine? What kind of connector does it have (2 wires, 3 wires, etc)? What I'm hoping is that there's a place on my engine I can remove a pipe plug or something from and just screw it in and go. It's a lot cheaper than trying to rig something up using an industrial pressure sensor.
so I thought I'd ask here. Where does it mount on the engine? What kind of connector does it have (2 wires, 3 wires, etc)? What I'm hoping is that there's a place on my engine I can remove a pipe plug or something from and just screw it in and go. It's a lot cheaper than trying to rig something up using an industrial pressure sensor.
