Breakoff screw size

[bstrong]

I would like to replace both the breakoff screw, and sloted screw on my AFC housing with a hex or allen head. What are the sizes of these two screws?

Just addes pyro, boost and trans temp on the pillar, and a #8 plate. Took it for a drive, and knew immediately that I was in trouble. I guess I'll have to go see Bill K. and Piers here pretty quick. Trans is wasting to much of that power, and it defuels at about 2700. Just can't have that now, can we?

------------------
'97 3500 auto CC 4X4, 4:10, 40,000 miles, TST #8 slid forward . 030, Isspro pyro, boost and trans tmp on the A-pillar. Soon to have DTT TC and VB.

 

[DavidGardner]

BSTRONG
I dropped one of my screws when I installed my TST plate and couldnt find it. I didn"t want to use the new breakoff screw that came with the kit incase I ever want to remove the plate and put it back to stock. Heres what I did. I removed one of the screws that had the reagular head on it and took it to Tacoma Screw They have every kind of bolts ect. in the world. They matched it by size thread size and length. Pluss they made sure it was of the same strength as the stock screw. They wernt to expensive so I bought a couple just to have on hand in case I loose another one. Hope this helps.
PS. You dont have to go to tacoma screw any good hardware or bolt store will do.

------------------
95 slt, reg cab, 2wd, auto, BD exhaust brake, primelok fuel filter relocator, K&N air filter, Cat sleeping in garage by fire, TST 230-605 fuel plate, Bill Kondolay modified trans, 100k plus miles still going strong "Who says six in a row don"t go?

 

[Rammin On]

The size is ... . 6mm X 1. 00 X 18mm