Cab wiring access?

[Hummin Cummins]

Ok, I couldnt thing of a decent title for this thread.



I'm getting ready to install an Edge Insight CTS w/ pyrometer, and also in cab controls for airbags. Was hoping you folks could save me some trouble and point me in the right direction for good access points from the engine compartment into the cab and from the underbody into the cab.



What route have u used to run wires, etc. from outside the passenger compartment to within? Drilling / hacking involved or are there some hidden access points someplace that doesnt involve dismantling the entire interior? I hate ugly wiring and hoses, like to keep things hidden and protected as best as possible.



Thanks in advance.



Chris

 

[n7gxz]

I poked through the rubber boot around the factory wiring harness.

Kevin

 

[Hummin Cummins]

Good deal. I was hoping there would be something like that. My 2nd gen had plenty of room in that grommet.
Thanks

 

[Hummin Cummins]

Good deal. I was hoping there would be something like that. My 2nd gen had plenty of room in that grommet.

Thanks