Calling All Albertans! (even BC and Saskatchewan guys!)

[MDKram]

You knew you did not have to ask, right Mr. Hansen? Those in Edmonton (or area) wanting advice/help with BOMBing before the July event, send me a message offline.



Regards, Marc

 

[JHansen]

I am seriously gonna try to get up your way Marc before July to hang out for a little bit. I actually was in Edmonton a couple weeks ago-but it was a quick trip in and out so I didn't call you..... my bad! I was severely hung-over to boot so you probably wouldn't have gotten much out of me anyways.....



I gave your email address to a fellow TDR member in Edmonton-hope that was OK? Figured the 2 of you could become a veritable BOMBforce!



I am very close to pulling the trigger on a turbo upgrade and bigger injectors. This will hopefully be the last major power step for me -I've said that every time I buy something. I KNOW I'm done buying fueling boxes now..... but I just can't make enough smoke so it's time for another upgrade! Was supposed to do my clutch yesterday but my machinist of choice is on holidays for the week so I have pushed it back 2 weeks now. Once it's in and seated, I'll be ready to upgrade. In 1 fell swoop I plan to put on a Scotty Air, someone's bigger and better turbo, remote exhaust brake (to replace the Jacobs I have now), the mandatory 4" down pipe, an ATS exhaust manifold and the aforementioned bigger set of injectors. My Visa is gonna take 'er hard... ... at one time I figured I'd offset the cost somewhat by selling my HX35 and E-brake-but Dad now has a lazy 1st gen that would benefit quite nicely from the above so I'll be making a phone call to Piers for the stronger exhaust springs and then I have magically created myself another project! That old girl needs valve cover gaskets and a valve set anyways... . so what's a little spring change right? I need to either clone myself or get a job where the shift is 5-and-9 instead of 9-and-5... ... .



Maybe we'll try to work up a miniature BOMBfest in your part of the world in June sometime... ... I'll see what's up my sleeve and let you know!



Jason