Here I am

Engine/Transmission (1994 - 1998) Can someone Identify this part?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
Status
Not open for further replies.
I believe that is the CAD. I forget what is stands for, but it slides the fork in the axle tube to engage the front axle for four wheel drive.





Marty
 
If fluid is coming out the vent tube I would have to be due to more getting into that housing itself either water or the seal that seal it off from the front differential housing and fliud may of want bad and your fluid from the differential is getting into the axle disconnect housing some how is my thought
 
It is the vacuum shift motor or "center axle disconnect" inside a splined sleeve is resident on the outside shaft (right), when the T case goes 4WD a vacuum switch (valve) draws air from the left chamber, sliding the sleeve left to capture and lock the center shaft to the right wheel shaft, all while the T case is spinning up. At the END of its travel it depresses the switch pin shown left, lighting your 4WD. All in all it is a stupid system (compared to an electric lock) suceptible to leaking (so it doesn't lock) and a great way to bring water from a puddle (if your fittings leak) up into your vacuum pump and crankcase!!
 
It is not uncommon for the system to "burp" a slug of oil out the breather, Check the fluid level and make sure the it is not over full or "milky"
 
Status
Not open for further replies.
Back
Top