2nd Gen Non-Engine/Transmission Carrier bearing again !!!

[WantaCummins]

Hi, My carrier bearing slipped out of the rubber housing and went toward the front of the truck. It only had 6,000 miles on it the last one was making noise. I only have mild mods see sig and wasn't abusing it at the time . Doing research on here someone suggested traction bars due to axle wrap. Could that be the problem or can there be something with the shaft. I only have a 2" spacer in the front nothing in the rear yet so driveshaft angles aren't a problem ( I learned that lesson with my Powerjoke:{ ). I love the truck and don't want to sell it but i have a rule that if the same thing breaks 3 times in a reasonable time period the truck HAS TO GO !!!! Any help is appreciated. Thanks BOB

 

[Sled Puller]

Contact Mark at Greensburg(PA) Machine. 724 837 8233

 

[WantaCummins]

Thanks Gene You told me to check him out last time it broke but at that time i didn't have the time to fab up the mounts and had to spend the $$ at the dealer. He was extremely helpful, I'll call him tomorrow and hopefully i can have it done by the weekend cause a 65 mile one way ride to work in a 78 Bronco with bias Swampers is going to be rough!!!

 

[Sled Puller]

 

[Beast2B]

You can try getting ahold of Jesse at www.highangledriveline.com

He built a CV rear two-piece shaft for me, works great - no vibration ever.

P. S. I am NOT affiliated, just satisfied