Here I am

Chip comparison chartfor 2005? Whats your favorite setup?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

APPS wire for a 05

Fuel filter change

Status
Not open for further replies.
I just bought a 2005 and was wandering what you guys were using on them. I have a 2003 with a BDDL and TST with a HTB2. Has anyone tried this on the 325 engine? Or is there something better now?
 
I have tried a couple of different combos... I like the TST PMCR the best... I was running a BDDL, and liked the low end power, but do not like messing with the ECM code on this 05. You will find out what I mean when you start getting P0299 after a turbo change... .



Long and the sort of it is that my PMCR is out getting the twins/ cool down timer reflash... When it gets back, I am going to get a VanAakin 3. 1 from Tomeygun for the low end...



The Edge Juice w/attitude is very nice, with the best presentation and programability, but the power is not quite as much as the TST...



However, if you want the EDGE, I have one New in the box with the most recent software that I can sell you. .



Cheers, Bill
 
I also have tried a number of stack combinations, getting more aggressive as the mods have allowed.



HOT Juice/Attitude & EZ stack was a very good combo. No codes or driveability issues at all. Power was very consistent and EGTs very low compared to most others. That stack dyno's about 475rwhp and ran consistent 13. 8s 1/4 miles.



I ran the TST PMCR and BD Triple Dog Performance program for about a month. It was pretty good, but just had to see if I could help low end lite the SPS66 quicker.



I am now running TST PMCR (w/Twins Program) on 7/7, BD Triple Dog Performance program and an EZ Level 2 stacked. Just put this combo together Friday. Dyno's 522/930 and ran 13. 27s 1/4 yesterday. The EGTs get high after locked put shift to OD during a 1/4 full run. I suspect this is partly because the injection pump/rail is not able to supply the requested fuel pressure correctly on the high end.



I am probably done with mods for this year, but next year I will be waiting for a modded CP3 to go with injectors, studs and maybe a friend for the SPS66. .
 
Status
Not open for further replies.
Back
Top