Here I am

Christmas wish list.

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

putting a bench seat in a 1st gen.

DTT trans dyno #'s ???

Status
Not open for further replies.
Ok guys Christmas is 2 months away and coming qwick. Regardless if you've been notty or nice, the trucks need their TLC.



Santa's sled must have a Cummins in it too haul a** and carry all those parts. So what would you guys like Santa to drop off under the tree. Santa lives up north and can make it happen.



Me, I'm hoping for a low 13 sec pass. Make more shows and dyno over 400 hp. Is it possible?

Santa needs to drop off new teflon/ceramic marine pistons, exhaust header, 5 " exhaust, special turbo setup ;) , new injectors, stage 3 ported / polished / o-ringed head with over sized valves and more fuel.



I think this would do it. :D



mark

P. D. R. - Black Sheep Racing
 
I'll second formula on the DTT transmission.

But I've been real good (haven't done a brake burner in a whole month!! :D ) and I need a front axle rebuild, Piers to set up a shop within a days drive of me and a large boot to kick much er. . butt!! :D
 
T'was the nite before Christmas and all through the garage,

not a creature was stirring,

not even my Dodge.

The tires were hung on the wall with care,

in hopes that St. Nick would fill them with air! :-laf
 
rfitzgarrald... . :-laf :-laf :-laf good one bud... . :-laf :-laf :-laf

for a minute there I thought you might say ' hair ', but I guess your not follically challenged.



bob.
 
Status
Not open for further replies.
Back
Top