Here I am

Archived Clutch advise

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Archived charging problem

Archived Sudden BAD driveline vibe @ 5-10mph

Status
Not open for further replies.
Im attempting to R/R the clutch in my 98 CTD 5 speed. I need someone to walk me through this with as much detail as poss. Will I need a transmission Jack or will my regular floor jack do the job? Is there any place on the sight I can go for a how to artical on this :confused: Thanks Otis
 
Well this helps a lot. I will get a trans jack tommorrow. The clutch hydrolic thing that bolts to the side with 2 nuts on studs is being a little witch, The studs are turning with the nuts so Im hoping to be able to just clamp a vise grips on the spinning studs and then replace them when I get everything is apart. The nuts and bolts on the crossmember are incredibly tight. Barly got them off with a long breaker bar. Im still not clear as to how to get the exaughst bracket off the crossmember. I can see a bolt on each side so Im assuming that when the trans is supported by the jack and the 2 bolts are removed that this will allow the bracket to slide off and out from between the crossmember and trans. ??? Thanks agian Otis
 
Status
Not open for further replies.
Back
Top