Here I am

Engine/Transmission (1994 - 1998) Clutch Fork ?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

2nd Gen Non-Engine/Transmission e brake cable

Status
Not open for further replies.
I'm installing a NV4500 transmission in my truck. I'm almost back together. After getting the transmission in, I couldn't remember if I installed the clutch fork with the part numbers on the correct side. I remember looking at it and looking at the numbers and thinking it has to go in this way but then I got distracted by my brother in-law who was helping. I'm 99. 9% sure it is in the correct way. I put the transmission in gear and had someone depress the clutch pedal and the output shaft on the transmission turned freely by hand so it is disengaging. My ? is will I know immediately upon start up if it is in wrong and does my test prove if it is installed correctly? Sorry for the long post. Thanks Pete
 
Status
Not open for further replies.
Back
Top