Here I am

Cp3 bag of parts?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Wireless control module

Need to vent?

Status
Not open for further replies.
The truck has a rail plug in it, the bag of parts is rated to flow between 15-19% over stock, my 100hp injectors are 30% over stock, withe the programming turned up it can still out run the fuel supply. With a pressure box it held at 27,000 psi, I dont know what the dyno numbers would of been with the pressure box, as I didn't run it, I ran the truck as it was set up daily on the street.
 
Running plugged is another wallet suck up device. The only People that will support that device are the one's selling them. I here it all the time been running plugged For years then BAM $$$$ later.
 
Just got home yesterday and ran the truck at the dyno event in Spokane, cp3 bag of parts worked out great, rail pressure still drops, but only to about 17,000, then recovers almost immediately, and holds about 22,000, at wot on the dyno, on the street driving normal, and playing a little it is between 20 to 26,000. I'm definitely happy with the performance of the bag of parts, 550hp and 1300tq with the ol 37's.



I had to miss the SCC event yesterday, with my house up for sale and running back and forth between wa an MT, just could not make the time.



Nice numbers, did you run lvl 6 on the Edge?, If so, you may have made more power on lvl 5. You would not drain the rail early, and save that fuel for top end. I learned this early with my TST, if I set the torque above 2, it would tax the pump early down low and not leave enough up above for max hp.



Glad your happy with the BOP, my rail has been capped for over 7 years, I took my banjo bolt to Fasteners and had them match it with a solid bolt. I agree with Todd it's risky, but so is walking out of your house...
 
You can run capped for years,As long as you only go too the edge,NOT over. Running capped is hard on injector components and will shorten their life,When I was testing spikes we had 3 LV installed 26k,28,30k and at times 32K, We ran all these into containers,even the 32k had fuel in the container. All of these spit at shutdown about 50% of the Time,One member of Comp has containers on his 28K, 30K setup he has posted picture of them holding fuel on COMPD, He keeps a good eye on them and dumps Monthly.
 
Status
Not open for further replies.
Back
Top