Dana 44 Front Axel HELP

[JTBMC]

Howdy Again,

Can Anyone tell me where to find front wheel spindles for a Dana 44 Axel w/ full time hubs on a 1987 Ram Charger. I was going to put Warn Locking Hubs on and discovered that I had spun a bearing and distroyed the spindle on the drivers side. Wheel bearings,seals & roters are available, but all the Parts houses including NAPA say spindles and locking nuts are no longer available.

HELP, TJ

 

[JoeyD]

I would try the local junk yard. You may have to buy the complete axle but you will get the parts you need plus extra.

 

[FFutch]

Randys ring and pinion

If you can't find it anywhere else,try Randys ring and pinion(1-888-231-2419). He carries a lot of hard to find chrysler stuff. I've dealt with him a few times and he's very helpful and prices are reasonable. I'll also look around my place and see if I've got one,(I've got a lot of spare truck parts laying around). Doug

 

[ET]

parts

if all else fails here is a link to a site that i used just last week to find a rean end for my truck. parts they have a great search engine for stuff like that.

 

[JTBMC]

Thanks Guys,

I've checked the local Junk yards and thier as scarce as Hens Teeth. I'll keep looking , Thanks Doug I also have tons of spare parts that my Wife an Daughters call junk but no Spindles.

TJ

 

[willyslover]

try JP magazine or any good off road 4x4 mag... . should be some in there as that is a very common one used for upgraded Jeeps

 

[NVR FNSH]

Dynatrac in the LA area or Border Parts in Spring Valley (San Diego) may be able to help you out.



Brian

 

[Scot]

Try Four Wheel Parts Wholesalers. If anyone has them, they do. I do not have a web address but I think they are on the net. Good prices and service.

 

[fj40charles]

Might want to check out pirate4x4.com web site. This is a site for hard core 4 wheelers and I spend too much time there too.



Charles

 

[Case500D]

I spun a bearing on my '92 W-250. A new spindle was $325. So, I had it welded up and turned back down to the correct size. It cost my $50 and is a good as new. Hope this helps.



Jeremy