Defueling

[scottmcd]

Started truck after sitting for 1hr, sitting @ idle, ran fine then seemed to defuel, almost to stall, then came back to regular idle. Has run fine since, but threw CEL, have not check for code yet. Were can I get the code read? Thanks

 

[GerryDrake]

read codes

Turn the key on (not to the start position, just 'on') then off, on, off, on. I think it is 3 times total, then watch the numbers appear under the speedometer... . what is 'CEL' ???

 

[crawler]

CEL = Check Engine Light

 

[scottmcd]

I didn't see any codes come up when I cycled the key, although the light has disappeared... .

 

[GerryDrake]

codes

Did you get some zeros ?..... if so, no codes... if not, either my explanation was inadequate or you did it wrong...



Cycle on-off-on-off-on without starting it and either codes or zeros indicating no codes should show up...

 

[scottmcd]

did not notice any thing come up on dash, can i try it again, or has the problem/ code gone away

 

[scottmcd]

retrieved code

retreived code P0336... what is the meaning on this code???

 

[GerryDrake]

codes

by going to



http://autorepair.about.com/cs/troubleshooting/l/bl_obd_main.htm



you can look it up.



I did, something about crankcase position sensor, but way beyond me, even for a guess...

 

[scottmcd]

had this same code right after having my Banks system installed, dealer checked, said everything was ok and reset. anyone know where i can get it reset.