Here I am

Does Anybody Have?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Measurements of PDR intercooler

Happy Birthday Tugboatphil

Status
Not open for further replies.

PToombs

TDR MEMBER
Does anybody have a fuel filler neck, the box end (top) they wanna get rid of real cheap? Like for shipping? I put in my 'charger tank, but the neck from it is rusted bad and has a hole thru it. The one from my parts gasser has a small 3/8 or 1/2 inch vent tube. The diesel and ramchargers are 3/4.

Oh, and mostly rust free would be nice too! (I know, I'm asking a lot!) :-laf

Thanks guys!
 
I have one from a 93 D-250 sitting in my back yard still connected to a tank.

I'm sure it would work if you cant find one closer to you
 
SA, not sure if a 2nd gen one will work. I'm putting it in an odd location, need a certain bend. I checked the rusted one against the one on the truck, they are the same. I'll look at my '95 gasser and let you know.

Thanks
 
I put in the one from the gasser, with the 1/2 " vent, for temporary. I wanted to get the bed back on so I could drive the truck before Dyno Day next Saturday. I think I'm going back to the U-Pull-It next week and look. They had 3 ramchargers and a few pickups. When I went the first time, I was looking for the plug on the sender, and wasn't thinking about the filler yet.



pete
 
Hey Pete is that the p&p next to the thruway? If it is COULD YOU PLEASE check and see if the RV next to the fence (by the main building) has any wheels and good rubber on it? (19. 5)? It would be appreciated because i can never get over there before they close. They are for my RV. Thanks Pete JLIGHT
 
Yeah, J that's the one. I'll have to make myself a note, the younger I get the more I forget! :-laf It's going to be next week.



I just ran up to look at their price list for hours, none on it. Phone # is 315-656-7533.



I'll let you know,

pete
 
Status
Not open for further replies.
Back
Top