Here I am

Doh!

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

It's Finally Here!

Half-price transmission drain plug/temp sender bung!

Status
Not open for further replies.
I took out my dashtop, installed my gauge pod, then took the dashtop back to the truck to reinstall. Then I saw it - I had the dashtop reversed on the workbench when I did the installation. My gauge pod was on the passenger side facing the windshield. That would work gfreat if I sat on the hood while driving! ... back to the drawing board...



" :-laf over the hill? what hill? I didn't see any hill!"
 
I have One for You,Pryo Senor In the Tailpipe,Owners comment was ,never had a problem with EGT"s. Installer also extended the wires,and it work???
 
TWest said:
I have One for You,Pryo Senor In the Tailpipe,Owners comment was ,never had a problem with EGT"s. Installer also extended the wires,and it work???



:eek: No way!



I can't tell how many times I've "completed" an assembly only to find I forgot a part. I do it all the time with forgetting to put the heat shrink tube on an electrical project before I solder the wires in place.



My worst one ever was forgetting to reinstall the input shaft on an A4LD automatic transmission I rebuilt for my old Bronco II. Had to re-remove the transmission, of course. :rolleyes:



-Ryan
 
Status
Not open for further replies.
Back
Top