Draw-Tite front receiver

[JR2]

I too have a mopar brush guard and want to install a reciver. Has anyone done it?? I would use mine for moving my toy tralier around the side of the house and to install a temp light bar with the aircraft landing lights on it...

 

[RobG]

That etrailer place is nice... too bad they want $30 to ship that receiver. If it wasn't so high, I'd get one... but odds are I won't use it anytime soon, so I'll just have to wait. I'll bookmark the place for later though.



Rob

 

[David Muench]

Shipping was $10 from miley.com (total $116 I think).

 

[vc]

Cooker,

I have a HiddenHitch on the back and it's been great so far. I replaced the factory one when I started towing heavier loads than what it was rated at. For the front, I'll eventually get a HiddenHitch also. They come with the loops welded on too. I can get it locally from a accesory shop for $90.

vc

 

[Cooker]

Thanks VC.



I guess I will shop based upon price. I would imagine they will both suit my needs just fine.

 

[RACE427]

Draw-Tite

Installed the Draw-Tite front receiver with no problems, I had to cut out a square hole in the center of my lower air dam so the receiver would fit through. Cannot see the purpose of having a truck without some kind of pulling device mounted to the chassis goosenecks.

This setup will work out fine and Draw-Tite makes a nice neat product that will accept alot of accessories. Thanks to all who replied!!