Here I am

DTT Smart Controller owners please

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

How to get Carbon Fiber 0-60 Boost Gauge?

PDR HX-40 back ordered

Status
Not open for further replies.

DBCooper

TDR MEMBER
My new toy arrived today (2 days from order to door. Gotta like that!) and as I was looking over the directions, I was trying to think of the best place to put the box itself. Where did you guys put it, and how do you like it there. I realize that there won't be much messing with it after it's all set, just wanted to know of any ideas you guys might have. Thanks

Dan
 
I put Velcro an the back and side of the controller. I then put it on the floor under the drink catapolt. I put the small side on the floor and the bottem of it on the plastic cover. I stuffed the plug under the cover and strapped the cord to the cover. I cant take a picture because my camera is gone... ... ... ...
 
I installed mine in the glovebox. There was a hole in the back of the box for the cable to go up under the dash. It's out of sight and easy to adjust. So far I have left it where Bill set it.
 
It's a mess...

I liked what Stefan Kondolay did when he mounted the box in his custom center console. You sometimes need to see the LEDs, especially when you are adjusting the unit. As for me, I’m still trying to decide how to mount what I have and what I plan to have. Mine is on the floor under the passenger’s seat.



<img src="https://www.turbodieselregister.com/user_gallery/sizeimage.php?&photoid=2008&width=1"
 
Mine is i nthe glovebox, i can adjust it easy on the fly this way,and its much safer than under the seat in my truck,where there is already a mini toolbox,amp,amplifier,and cd changer taking up space.
 
I can look at mine if needed; however at times I would like to know for sure if the t/c is locked. Have thought a few time about putting a red led on the piller guage mount. Maybe one day-----
 
I also attached velcro to the back and stuck it on the floor right in front and to the right of the transfer case lever, to the cover for the airbag sensor ( 94-97 layout ). I like looking at the lights and easy to adjust.
 
I have a radio rack setup on my transmission hump. I put velcro on it and attached to the top of the roadrelay. This way I can see the event lights and keep it cooler.
 
Status
Not open for further replies.
Back
Top