Here I am

Edge Juice with Attitude Question

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Yet Another 04.5 Mileage Question

Edge Vs. Tst

Status
Not open for further replies.
I do not see anything on the Edge web site on the Juice/Attitude for the Cummins 4. 5 600 yet. I would like to look at the install manual and documentation. Where can I find this information???



Thanks
 
JVolpe said:
I do not see anything on the Edge web site on the Juice/Attitude for the Cummins 4. 5 600 yet. I would like to look at the install manual and documentation. Where can I find this information???



Thanks



That will cost you several hundred dollars... . And it comes with a computer and guages! ;)
 
smoke, they are about 8" apart. One, the coolest, is drilled in the round flat spot(this is on ATS man. )just ahead of the expansion joint, this probe is verticle, the hotest reading is just above the turbo, towards the rear where 5 & 6 dump into the turbo, this one is horizontal. There was as much as 150* difference bet. the 2, and when we switched the guages and probes, they read the same difference. So the difference is where the probes are located, not in the guages. I hope thats clear.



Larry
 
yogibear said:
smoke, they are about 8" apart. One, the coolest, is drilled in the round flat spot(this is on ATS man. )just ahead of the expansion joint, this probe is verticle, the hotest reading is just above the turbo, towards the rear where 5 & 6 dump into the turbo, this one is horizontal. There was as much as 150* difference bet. the 2, and when we switched the guages and probes, they read the same difference. So the difference is where the probes are located, not in the guages. I hope thats clear.



Larry



I can kind of see where that could be the case, maybe this is crazy talk, but when you are going to heat something with a torch you point the flame at a 90 degree angle and it will heat faster than if you are running the flame parallel to what you are trying to heat, atleast it seams that way, so that could be why the difference. This is just a thought, it might all be bogus :confused:
 
Status
Not open for further replies.
Back
Top