Attention: TDR Forum Junkies I'm smack in the middle of doing a rear wheel disk conversion on a 1993 Dodge W250. The new rotors do not work with the old wheel studs. I can't get ahold of EGR for help. The rotors they sent me are PVR8512. I'm not sure what application they are for.
The OEM wheel studs have a shoulder diameter of 0. 680". The new rotors have stud holes of 0. 650". The OEM stud heads are 1. 020" diameter and the rotor stud hole pockets are 0. 930"
I'm wondering if they sent me the correct rotor or if there is a different wheel stud I can use. I tried the local NAPA but they do not stock anything to try. Anyone had this problem with the EGR system? I need my truck back on the road by tomorrow!
Jay
The OEM wheel studs have a shoulder diameter of 0. 680". The new rotors have stud holes of 0. 650". The OEM stud heads are 1. 020" diameter and the rotor stud hole pockets are 0. 930"
I'm wondering if they sent me the correct rotor or if there is a different wheel stud I can use. I tried the local NAPA but they do not stock anything to try. Anyone had this problem with the EGR system? I need my truck back on the road by tomorrow!
Jay
