Engine Codes

[zues]

Does anybody know what these codes are? I read this with the Bully Dog Pup.

P3201

P1806

P0206 Fuel Injector 6

P337

 

[manganos]

do a search

Does anybody know what these codes are? I read this with the Bully Dog Pup.

P3201

P1806

P0206 Fuel Injector 6

P337

If you do a search you should find all the info you need. Were you running on e of the downloads when you set the codes?

 

[zues]

I was on the performance program

 

[rbattelle]

I don't have P3201 or P1806 in my Powertrain Diagnostics Manual (PDM, 2003).



P0206 - Injector #6 Control Circuit

Set Condition: when the injector current falls below a calibrated threshold.



P0337 - Crankshaft position sensor voltage too low

Set Condition: voltage detected is below a calibrated value for a calibrated amount of time.



In my opinion, blame for these codes lies squarely upon any aftermarket fueling box you might be running. Try removing it and see if the codes go away. I don't think there's been any instances of anyone actually burning out any sensors or injectors as a result of using a fueling box.



-Ryan

 

[LMcCary]

LMcCary

If you have several areas in which you have low voltage,then you have something pulling down the regulated volts from your ECM. If your voltage is high to those areas, then you have lost ground to the ECM. Please recheck your wiring. If you don't find the problem, Disconnect the add on box.

 

[zues]

Thanks for the info. This is suck a great site.

 

[Gary - K7GLD]

"Thanks for the info. This is suck a great site. "



ACTUALLY, it only "sucks" on rare ocassions... .

 

[Jdimig]

This is suck a great site.

Oh realy!?

 

[zues]

So So So So So SORRY, I need to read post before posting. I meant SUCH a great site.