engine codes

[BradHanson]

where can I go to find what the codes mean. I have a p0633 that my bully dog can't erase.

 

[CKruse]

Try this: http://www.canobd2.com/support/DTC_lookup.asp



I keep a printed list in my truck, (never needed it!) but don't remember where I got it.

 

[HCR552]

Could you send me the list please? Scan it in and email it to me please?

 

[YFZBOB]

where can I go to find what the codes mean. I have a p0633 that my bully dog can't erase.

IMPROPER IGNITION KEY IS BEING USED

SKIM DTC’S

SKIM NOT CALIBRATED PROPERLY



From the manual...



Diagnostic Test



1. SKIM DTC’S

With the scan tool, read SKIM DTCs.

Are any SKIM DTC’s present?

Yes >> Repair all SKIM DTC’s first.

Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL). (Refer to 8 - ELECTRICAL/ELECTRONIC

CONTROL MODULES/ENGINE CONTROL MODULE - DIAGNOSIS AND TESTING)

No >> Go To 2



2. IMPROPER IGNITION KEY IS BEING USED

Verify that the proper ignition key is in the ignition lock on the steering column.

Are the proper keys being used?

Yes >> Go To 3

No >> Use the proper key for the vehicle.

Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL). (Refer to 8 - ELECTRICAL/ELECTRONIC

CONTROL MODULES/ENGINE CONTROL MODULE - DIAGNOSIS AND TESTING)



3. SKIM NOT CALIBRATED PROPERLY

Using the scan tool, recalibrate the ECM with the proper SKIM secret key.

With the scan tool, erase DTCs.

Cycle the ignition switch from on to off to on.

With the scan tool, read DTCs.

Did the DTC reset?

No >> Test Complete.

Yes >> Verify information is correct and replace ECM.

Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL). (Refer to 8 - ELECTRICAL/ELECTRONIC

CONTROL MODULES/ENGINE CONTROL MODULE - DIAGNOSIS AND TESTING)