Espar Remote wiring help

[Archive]

Those plastic rivets (DC) do not require a tool. Just buy some new ones and push them in. Very simple. (I assume they are the same ones I used when taking off the front bumper.

They came with my OEM foglight kit that I installed after buying my 'off the lot' Ram.

 

[Archive]

Does anybody read German?

Filling out my Espar Critique form and it asks for the serial # on the heater itself.

Ausfuhr. Nr. = 25-1917
Fabrik Nr. =0740AL

I just listed them both.

 

[Archive]

Nevermind,

Its the Fabrick NO on the heater plate.

 

[Archive]

Thx

 

[Archive]

Bill,
I ran across the same thing. The paperwork they sent for the Critique had the Serial# printed so I used that one.

Bert

 

[Archive]

I started installing mine this morning.

My fuel line is about a foot short. Thats with it streched. I`ll see if it can find something locally.

I started at 9:00am. Quit at 6:00 pm. Have not started the wiring yet. That & fuel line last thing.

Tough job. Nothing goes together easy. No I see why it takes 20 hours. Iv`e never had a shade tree job where I did most of the work by feel. Its tight in there. Can`t see half the stuff.

The 1/2" pipe plug between #5&6 cylinder can be seen from below. Can`t reach it from below. Can`t see or feel it from the top. Tough to get at it. Took me 90 mins the R&R it with a hose barb... .completely by feel #ad


What a nightmare #ad


------------------
Bill R
94 2500 SLT 4x4 5 Speed, 3. 54 LS, JRE 4" exhaust, Autometer Pyro, Boost & Water temp gauges, Bosch 215 HP injectors, Timing @ 14. 7 º, JRE Stage III #4 plate 270/675, AFC spring kit, Scotty Air, Bully Dog Propane Injection, Roadmaster Active Suspension, Optima Red Tops, Geno`s Exhaust Blanket,Espar Heater (won it!), Synthetic lubes throughout.

[This message has been edited by HEMI®Dart (edited 09-30-2000). ]