EZ Boost Elbow

[Challenger-II]

Does anyone know if just the boost elbow for an EZ is available from Power Edge?? If so, what is the approx. cost??? I am interested in a used unit for my '99 that I found for sale but the seller doesnt have the elbow. :{



Thanks all!!

 

[redneckdr]

boost elbow

there are a lot of ways to modify the waste gate operation. contact Edge, i'll bet they'll sell you just the boost elbow. if not, i am sure i've seen one from someone else--just can't remember who at the moment. a turnbuckle arrangement is one alternative. if the price is right, and the MAP plug is right, go for it.....

 

[M Barnett]

http://home.att.net/~jason510/ManualController.htm



Check out this website

 

[Ted Constantine]

Challenger,



I have a a friend that is not a member but has a boost elbow he is willing to give youOo. Email me it is in my sig and I will hook the two of you up.



Ted

 

[K_Arts]

Originally posted by Challenger-II

Does anyone know if just the boost elbow for an EZ is available from Power Edge?? If so, what is the approx. cost??? I am interested in a used unit for my '99 that I found for sale but the seller doesnt have the elbow. :{



Thanks all!!

Just and FYI, you can go to any hardware store and purchase one. The elbow is just a simple 1/8th inch NPT elbow that will allow a hose to connect up to one side.



I actually purchased a spare at Home Depot. I went over to where they sell accessories for Propane tanks and whoola. It is the same elbow that edge supplies.



Just my $. 02



Kev

 

[Challenger-II]

Thanks for the tip Kev... . Doesnt the elbow have a bleed off hole drilled in it? What size hole is it? Oo.

 

[K_Arts]

Originally posted by Challenger-II

Thanks for the tip Kev... . Doesnt the elbow have a bleed off hole drilled in it? What size hole is it? Oo.

The elbow that I got from Edge didn't have a bleed off valve drilled into it. One side is the standard 1/8th NPT which had just a pinhole size opening (same size as the propane fittings) and the other side kinda came to a point where the rubber hose from the the turbo just clamps right on. I can post of a pic if it is of any help. . ??



Kev

 

[Challenger-II]

Originally posted by K_Arts





Kev

One side is the standard 1/8th NPT which had just a pinhole size opening (same size as the propane fittings) and the other side kinda came to a point where the rubber hose from the the turbo just clamps right on. I can post of a pic if it is of any help. . ??



Picture??? Any help is appreciated!!!!



Thanks again!