Attention: TDR Forum Junkies 
I recently ordered the 2-micron filter/water separator from Industrial Injection. It goes in place of the separator.
I installed this filter, and also a new 10-micron filter. I thought the filters would prime, but they did not. I got some diesel and filled the filters.
When I turned the key, I got 20psi of fuel pressure and my truck started. After about 20-30 seconds, my truck started idling rough and died.
Now there shows no more than 4psi of fuel pressure, and my truck won't run.
Any suggestions? I plan on getting the original style filters tomorrow afternoon and trying to fire the truck again.
I put the new filters on, keeping in mind swapping out the little rubber washer on the separator.
I installed this filter, and also a new 10-micron filter. I thought the filters would prime, but they did not. I got some diesel and filled the filters.
When I turned the key, I got 20psi of fuel pressure and my truck started. After about 20-30 seconds, my truck started idling rough and died.
Now there shows no more than 4psi of fuel pressure, and my truck won't run.
Any suggestions? I plan on getting the original style filters tomorrow afternoon and trying to fire the truck again.
I put the new filters on, keeping in mind swapping out the little rubber washer on the separator.
