I have a 2001 24v 2500 2wd with 39k miles. I have a Banks Stinger kit.
Last week, the check engine light came on, checked the code sand got the 1593 and 0216. talked to Banks, they said "yank the yellow (spliced into the VP44 control) wire". I did, codes went away, truck ran fine without the Ottomind hooked up.
I guessed that the LP was going out, I had noticed it was noisier lately, so I ordered the FASS kit.
My install was a total success (as far as cleanliness goes), it's a nice product and the install went cleanly and smoothly.
After the pump was installed, I fired up the truck, it started and ran for about 3 seconds, then died.
I noticed the FASS pump wasn't making any noise (I'm not sure I had all the electricals hooked up right: I got the optional relay harness and may have skipped a connection in my enthusiasm to drive the truck), so I dove back under the truck and bypassed the relay harness and ran the FASS pump harness direct to the LP wire.
Now, the pump runs for the 25 seconds after I key the starter, but the truck won't start. I have tried to start the truck now 4 or 5 times to the point of heating up the starter, just hoping there is air in the system, but I still have had no fire.
The error codes present are 1693, 0216, and 0230.
Can anyone give me a step by step troubleshoot for this condition?
I did loosen the inlet at the VP44 and I know it's geting fuel...
Thanks
Stuart Mumford
Riverside CA
Last week, the check engine light came on, checked the code sand got the 1593 and 0216. talked to Banks, they said "yank the yellow (spliced into the VP44 control) wire". I did, codes went away, truck ran fine without the Ottomind hooked up.
I guessed that the LP was going out, I had noticed it was noisier lately, so I ordered the FASS kit.
My install was a total success (as far as cleanliness goes), it's a nice product and the install went cleanly and smoothly.
After the pump was installed, I fired up the truck, it started and ran for about 3 seconds, then died.
I noticed the FASS pump wasn't making any noise (I'm not sure I had all the electricals hooked up right: I got the optional relay harness and may have skipped a connection in my enthusiasm to drive the truck), so I dove back under the truck and bypassed the relay harness and ran the FASS pump harness direct to the LP wire.
Now, the pump runs for the 25 seconds after I key the starter, but the truck won't start. I have tried to start the truck now 4 or 5 times to the point of heating up the starter, just hoping there is air in the system, but I still have had no fire.
The error codes present are 1693, 0216, and 0230.
Can anyone give me a step by step troubleshoot for this condition?
I did loosen the inlet at the VP44 and I know it's geting fuel...
Thanks
Stuart Mumford
Riverside CA