Engine/Transmission (1994 - 1998) Front crank seal

[Vaughn MacKenzie]

When I did my KDP and replaced the crank seal in the front cover I noticed there was rear on the crank snout and had concerns about the seal lasting. My truck had 355,000 on it then. Now 75,000 miles later it is really leaking and I want to go ahead and do the service sleeve. But reading on the board it takes a special tool to drive it on and don't even think about attempting an install without it. It is PN 3824500 and is about $200 just for the tool. I know it would be cheaper than taking the truck in and having it done.



Has anyone dealt with installing a crank service sleeve and been able to come up with the tool anywhere?



Vaughn

 

[GAmes]

I made one using a piece of pvc pipe and a cap. Picture on post #9. I recommend using some lube on the cranknose, that sleeve fits tight!

https://www.turbodieselregister.com...8/208472-front-crankshaft-seal-wear-ring.html



Also good advice about not pushing the seal to the same place which might allow you to use the stock size which saves $$ and aggravation.

 

[kenny61]

Whoever came up with that pvc idea sounds like a genius:-laf

 

[Vaughn MacKenzie]

I found a solution. . . Timken makes a service sleeve for Cummins and it comes with a slick little install cap. Timken PN KWK99248 & cost me $30 at a local parts retailer. Here's a pic More Information for TIMKEN KWK99248

Most of the time I buy Cummins & Fleetguard parts for my engine, but glad I called around this time and found out about this option!