Here I am

Engine/Transmission (1998.5 - 2002) front drive shaft u-joint

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1998.5 - 2002) Any ideas on clutches

Engine/Transmission (1998.5 - 2002) Lcarleton

Status
Not open for further replies.
what is the symptom of a bad front u-joint. I am getting a little play on it and a vibration around 1500-1900 rpms dont know if its related. I have a little bit of greese showing on the u-joint but not much. this all started about 4000 miles after I put my suspension lift on. so I guess this lift may have exposed a failing u-joint



2002 HO 6-SPD LB 4X4 QC HTT 62/14 SB-FE SMARTY TST PM3 MACH 4'S, RINGED AND STUDS, AFE/2:eek: "SILVERLINE D/PRICOL PYRO,BOOST,FUEL FASS 150, VULCAN 1/2 DRAW-STRAW, VULCAN 3/8 FUEL LINE AND FITTINGS, DSS 03 TRAC-BAR DSS BOX TURN-OVER BALL, RIDE RITE AIR BAGS. SUPPORT 17'' KMC BLACK HOSS, 315/70/17 MICKTHOM BMTZ'S 6" RCD LONG ARM LIFT AND DE-BADGED FOR FUEL MILEAGE. :-laf
 
Change it in your garage before you change it on the side of the road in the rain and cold!!! Also check your CV joint on the other end of your shaft... my lift took out three CV's so far! How big of lift did you get?
 
Sorry... Just noticed your sig! 6in? Also look into one of Skyjackers indexing rings for your transfer case! It takes the angle out of your drive shaft. Its my next purchase! Nothin worse than playin in the mud and throwin a driveshaft! #@$%!
 
Status
Not open for further replies.
Back
Top