Here I am

Archived fuel MPG problem

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Archived Intermittent Loss of Power

Archived Need quick advise on mechanic in NW GA (Hiram)

Status
Not open for further replies.
i did more test today and got it running with a little quick start. What i found out is that my rail pressure is at 5500 psi when ideling and at 10500 psi to 11000 psi at cruising speed(55mph) around 1400 to 1500 rpm. At full throttle the most i got was 16500psi. Tomorrow i will tray to swap COV with my brothers truck and see if i can get my rail pressure back. No codes.

Those #'s are normal, except your WOT # is low.

Have you tried starting the engine with the FCA unplugged?
 
Those #'s are normal, except your WOT # is low.



Have you tried starting the engine with the FCA unplugged?



I just unplugged it while it was running and it runs bur raddles. I also unplugged it and started it and it still starts but raddles.
 
Last edited:
Status
Not open for further replies.
Back
Top