Here I am

Engine/Transmission (1998.5 - 2002) Fuel pressure with FASS

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
Status
Not open for further replies.
Installed a fuel pressure gage for my 02 and get a steady 15 lbs. At full throttle with a skidsteer behind it would drop to almost 14 but no more. This seems good as far as consistency but is the idle a little low? I mounted the sending unit on top of the FASS but its not completely upright. DW
 
14-15 is fine, but it would be nice if the gauge was measuring right at the inlet to the VP. Where your sending unit is probably ok though.
 
Status
Not open for further replies.
Back
Top