Engine/Transmission (1998.5 - 2002) Fule pressure gauge

[TBrock]

Im putting on a fule pressure gage can any one tell me the best place to install the sending unit, is there a place on the IP for it



Thanks

Thomas Brock



PS. You guys are great Oo.



One other thang can any one point me to a triple gauge pod that will match my interier 2001 gray.

 

[Cummins724]

You can run it into the top of the fuel filter housing. There is a plug in the top that you can remove & install it there. The best place is at the ip, but you would need a 90 degree elbow that is tapped for the fuel fitting. The elbows are available from vulcan, but the filter housing is a good spot.

 

[Cummins724]

Im putting on a fule pressure gage can any one tell me the best place to install the sending unit, is there a place on the IP for it



Thanks

Thomas Brock



PS. You guys are great Oo.



One other thang can any one point me to a triple gauge pod that will match my interier 2001 gray.

The gauge pods are paint to match. I know doug at advance diesel technology paints them to match if you desire.

 

[Bob Cochran]

I don't think the 2001 has the place in the fuel filter top as described mine does not. I exchange the banjo that had the test port in thin inlet to the VP with the one on the fuel filter. Removed the valve core and connected the gauge line to it using braided steel line; that was the first time. The second time when I move the LP back to in front of the tank using the Vulcan 1/2" relocation kit there was a "T" in the line between the fuel fliter and VP and I know use it.

 

[WestTN]

You probably should not mount it on the engine. Too much vibration. Use a hose and remote mount it.