2nd Gen Non-Engine/Transmission gauge steering mount

[dclassens]

Like it says below, I have an 01 ram and would like to mount my gauges on the steering collum. Does any one make a dual gauge steering mount like pic below(the pic is for 03 and newer trucks) for 98-02 trucks?

 

[RPA]

I have not been able to find anyone that makes the 2 gauge pod. I don't think it is possible since the 4way flasher light switch is on the left side instead of being in the middle like the now body style.

 

[VHolloway]

look up GENOS GRAGE on line1800-755-1715

 

[JRihani]

Think carefully what gauges you would like to mount there. I bought the single steering wheel mount for my Westach FP gauge and I was not able to successfully install it in the gauge mount. I might just not be creative enough but it is something to consider when going this route. I'm getting ready to do a boost/egt and dual temperature gauge and the boost/egt gauge is even deeper than the FP gauge.



Regards,

John

 

[RBrunson]

I have the single mount on my 98 with the duel gauge in it. According to Geno's that mount is not susposed to work with the WesTach boost, EGT gauge. They say that the gauge will not clear the steering wheel. Well mine has prenty of clearance. I bought my mount from Rip at Source Automotive and it could be a little different from Geno's, but it looks just like their's.

 

[RClark]

I mounted my westac Dual gage with Geno's mount. However i had to do 2 things. There is a lip on the reont of the gage. Grind/sand that off. The mount can be fastened down on the door side but above the shift lever raise it up about 1/4". then the back of the wheel will clear the gage.