Here I am

gauges noisy

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Need my Build sheet..

Grenaded Carrier Bearing

Status
Not open for further replies.
Just got done with the install. Autometer ultra lite 2 series egt,transmission,and fuel pressure in the top dash mount pod. The gauges (all the gauges are electric)are very noisy. I am going to try tomorrow to isolate if its one or all,and wrap any wires in loom to cut down any possible vibration noise. Anything else to look for?Really annoying and if I cant fix it they are getting yanked. Need help!
 
Last edited:
Check your fuel pressure gauge. I also have the autometer fuel pressure gauge that makes alot of noise. A friend of mine has the same set up on an 02 that is silent. I can't figure it out and have just gotten used to it and don't even really hear it unless I pay attention to it.
 
I can here all of them,the fp gauge wasnt even plugged in so it wasnt working. The egt and transmission gauges are making a racket. Installed correctly(if thats your first thought),so I know its the gauges. Hope genos can send me some and see if its just them or nature of the beast(probably not). I had 5 guages on my PSD and none of them ever made any type of noise whatsoever. Dissappointing so far.
 
Mine is noisy too but I think it's the forward end of the dash top bezel thats vibrating against the dash it's mounted on. SOoooooo, I'm going to try and find some felt to put in there to separate them and see if that helps.
 
I know its not the dash,but thinking that I did loom the wires,rubber tape and then electrical tape to I am sure its not that. The dash is solid and I know its the gauges,just waiting to hear back and see what to do next.
 
I recently had gauges mounted in my truck and found the noise is coming in on the fuel pressure line from the vp44 to the fuel isolator. I had my wife hold the line and the noise stopped. I used some wire ties to cinch it up tight and it stopped almost all the noise.
 
Status
Not open for further replies.
Back
Top