Attention: TDR Forum Junkies 
A buddy and I were doing a draw straw install on his truck today and found something we thought everyone w/aftermarket frame mounted LP system should probably look at. I don't care who installed the system: you or the best shop in the world.
Do yourself a favor and check all the hoses from the tank module to the system pump and forward to the VP and make sure it's not rubbing a hole in itself along an edge of the body, frame or other bracket. Wire tie them tight to a flat surface or if they are routed in such a fashion that you can't re-route get a piece of larger hose, slice it down the length and wire tie it to the hose where it may rub against the edge as an extra thickness to protect against the obviouse unforeseen loss of fuel pressure = ending up along side the road, in a downpour or snow storm. An ounce of protection worth a ton of piece of mind . . .
Do yourself a favor and check all the hoses from the tank module to the system pump and forward to the VP and make sure it's not rubbing a hole in itself along an edge of the body, frame or other bracket. Wire tie them tight to a flat surface or if they are routed in such a fashion that you can't re-route get a piece of larger hose, slice it down the length and wire tie it to the hose where it may rub against the edge as an extra thickness to protect against the obviouse unforeseen loss of fuel pressure = ending up along side the road, in a downpour or snow storm. An ounce of protection worth a ton of piece of mind . . .
