Got my H2 Wheels and Tires on!

[yycguy]

Here is a picture of my new H2 wheels and tires. I have to thank this site and Hoot for the great info on getting these wheels to fit, a big thanks

It was really easy once you know what to do, I had a machine shop bore the wheels on a lathe and I did the caps myself on the table saw.

Hopefully this picture will attach!

 

[sootgrinder]

Nice looking rig. What do you have in the back?

 

[yycguy]

Nice looking rig. What do you have in the back?

In the back is a Quad/Snowmobile Deck, thanks for the compliment.

 

[DNichols]

Looks great Looking for some myself.

 

[FDavid]

So is it a Cummer or a Hummins :-laf

 

[yycguy]

So is it a Cummer or a Hummins :-laf

ohh man don't start that... lol

 

[Motobeagle]

Looks great. Reminds me to order a locking fuel cap.

 

[JKlopp]

Looks good. What did you have to modify to get the Ram caps fit the H2 wheels?

 

[DaryleB]

Hey nice looking rig... I just did this myself. Check out my pic.

 

[yycguy]

Looks good. What did you have to modify to get the Ram caps fit the H2 wheels?

Thanks, as for modifying the OEM caps it was really not that difficult. If you have a look at Hoots page http://home.comcast.net/~hoot74/dodge/

it has detailed instructions. I used a table saw and spun the caps on it to trim them to fit the H2 wheels I didn't take as much off as Hoot says on his site, I only took of 3/4 of an inch and that worked just fine. I used a bench grinder to trim down the locking tabs and it was done. About 3/4 of an hour at the most.