Here I am

Help more TPS problems?????

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Hey Steve, Need Help with EGT's

EZ computer with Low Power mode>

Status
Not open for further replies.
Hey Guys need some help with the TPS. I was having problems with lock-up and replaced the TPS. The truck ran great for about 2 weeks now it back to going in and out of lock-up. I tested the new TPS this morning and everything test fine. any ideas??????

Thanks in advance to anyone that can help.

1994 dodge 3500 dually 5. 9L cummins 3. 54 gears.
 
You are not going to like this. I had same problem with my 92. I went through 18 TPS in 30 months. Even the dealer was getting frustrated. We had a ritual going when it acted up I would come in, he would download the error, order new part, and replace it the next week. Well after a recorded error fault I had the battery die and replaced it; error codes were erased. With a bad TPS it should had thrown the error code out again it didn't. We found the problem finally at that time; it was the voltage going to TPS. The voltage is only like 1. 5-2 volts and is dropped from 12volts at the CPU so they replaced CPU and never had a problem again. This all started at about 12k and lasted to 35k so it was all under warranty.

In my opinon I would reset the error codes and find out if the TPS sends another error code right away if it doesn't then I bet you have a voltage problem also.

------------------
Eric Kelcher
92 W250 stock 4spd/auto 3. 54
96 2500 extd SLT Diesel Dynanics fuel pump plate; auto with DD shift kit(?) Dun-Rite TC; 3. 54 posi; K&N airfliter; Boost, transmission temp, EGT guages waiting for nice day; 192K
13. 5k 33'utility trailer 19' Galaxie runabout
 
I had the same problem and i changed the transmission temperature sensor, 18 bucks at napa. (I think it was only $22 at dealer). If i remember right it is a 7. 5k ohm resistor you can put in the temperature plug to test it. This will supposedly give the computer a 98 degree signal. hope this helps.
Nick
 
Status
Not open for further replies.
Back
Top