Engine/Transmission (1994 - 1998) help needed in North carolina

[rfull]

putting a 96 12 v in my ford and need somebody to help with setting the timing and killing the kpt before i get on with the install.



the core support is out and the mtr is there to work on but got transplanted here on short notice so i brought it with me to finish.....



i do not have the proper toold to do the timing or the kpt and will haul it to where i can get this done and meet some the other diesel guys up here



hauling with a f-800 8. 3c with 36' tilt deck trailer so i can deliver... .



give me a email

-- email address removed --



and thanks ahead of time... ... Oo.



. .

 

[Andy Redmond]

You might ask "Kentdiesel" I think he is from Hickory?



If a TDr DIY's, or an independant shop can't be found. Find a good Cummins Dist. or dealer. They likely have a tech that moonlights on or off premise. Ask them to bring a dial indicator kit for timing a b-series if you don't have one.



One the KDP, you can remove the front cover since the engine's out, tab and ck. bolts inside. You can also source a jig, and not have to remove the front cover, as long as the pin has not shifted significantly and interferes with the drill going to the jig stop.



Good luck,

Andy

 

[rfull]

thanks i figured there was some of the guys up here but?????



i got to fix the ft seal so its coming off anyway



i had time to build some mounts and load the truck ... ...



i need a few parts to finish it and was hoping for some locals to help



were do we get the linkage parts for the throttle?



my ends are wore out and the transfer lever(for lack of a better term) the whole thing

is flopping around... ... the weather has to get better for me to get on the stick!



thanks

 

[rfull]

bump to the top for some responses