Help, Where can I get a 19MM ALLEN WRENCH???

[roperteacher]

I want to change the Manual trans fluid and NONE of the parts stores carry 19MM Allen wrenches. I searched Auto Zone, Kragens, Napa. . the biggest they go is 10 MM... . Where can I get these???????? Please respond... thanks!! :--)

 

[Gary - K7GLD]

Many auto parts stores sell metric allen adapters for your use that snap on to a 3/8 or 1/2 in ratchet - usually about $5...



I bought a 17mm one for ny NV5600 from Kragen...

 

[Turbo1Ton]

I want to change the Manual trans fluid and NONE of the parts stores carry 19MM Allen wrenches. I searched Auto Zone, Kragens, Napa. . the biggest they go is 10 MM... . Where can I get these???????? Please respond... thanks!! :--)

Mine is a 17mm. Of course I have the NV5600. I don't know if the G56 is different or not.



Jeff

 

[roperteacher]

I meant to say 17MM sorry, I have the NV5600 as well... . So there is an adaptor I can get??

 

[jltcasper3]

Snap-on baby, you can get a regular allen wrench or a 1/2 drive socket style

 

[Turbo Tim 1]

Sears, Napa, Auto-zone, etc



Sears



Probably find one on Flea-Bay and it's only $1. 25 or A Whole Set for $25

 

[klenger]

#ad




15mm bolt and two nuts works just dandy too. Use an open end wrench on the inner nut to remove plug and on the outer nut to install.

 

[Bob4x4]

I meant to say 17MM sorry, I have the NV5600 as well... . So there is an adaptor I can get??

If you ever get up Corona way Mcfadden-dale industrial hardware has them.



Bob

 

[cArNiVaLwOrKeR]

If you ever get up Corona way Mcfadden-dale industrial hardware has the.



Bob

BoB4X4, what? has the???

 

[Bob4x4]

#ad




15mm bolt and two nuts works just dandy too. Use an open end wrench on the inner nut to remove plug and on the outer nut to install.

I have had some so tight they would twist a bolt till it broke :--)



Bob

 

[roperteacher]

Sears was the ticket!! Man these trucks are LOW to the ground!!

 

[Bob4x4]

Man these trucks are LOW to the ground!!

not mine



Bob

 

[nickleinonen]

I have had some so tight they would twist a bolt till it broke :--)



Bob

been there, done that. . pain in the arse

 

[roperteacher]

The hardest part was getting that last little bit of fluid squirted into the fill hole without it all draining out!!!!! When it's full, it's full!!! I got almost 5 qts in there before I had to put the bolt back in real quick. Klengers instructions said it would hold 4. 75 qts so I did pretty good!

 

[JLetcher]

Here's the set of metric hex sockets that I picked from Harbor Freight yesterday on sale for $12. I believe that I read that the G56 takes 14mm.



Harbor Freight

 

[mattk50]

i used klengers method. works great and cheap too!!