Here I am

hour counter and installation tips?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Smittybilt Stainless Steel Brush Guard?

New VA for HO

Status
Not open for further replies.
hi, all. i'd like to install an hour counter and would like to know which ones i should consider, which spot i should consider putting it in and how difficult is it to install?

thanks in advance.

------------------
regards,

peter
1998 24v 4x4 QC, SLT, Sport, Leather, Linex, snug lid, center line wheels, Smittybilt side steps,color matched fender flares, stull grills, tow hooks----first diesel, dodge etc. i'm in love!
 
Peter,I've used Stwert-Warner hour meters on lots of different equipment for years,they work fine. Recieved a flier from Surplus Center(800-488-3407)last week,they have govt surplus Faria hourmeters for $10,p/n 11-2288 that's about $30-40 less than elsewhere. Connect it up to any keyed hot wire and ground. If it was me I'd install it under the hood,they're tuff they'll take it.
 
back to the top.

i called that 1-800 number and ordered one (at the end of october) and two days later they called me and told me that they were out.

does anyone know of any more good deals out there on hour counters?

thanks in advance.
 
Several sources of hour meters;
electronic supply houses
forklift company parts dept.
farm equiptment supply

I have had good luck using Hobbs, Veeder Root and Stewart Warner

Neil

------------------
Neil Copeman 92 D250,LE,limited slip, 16cm turbo housing, Isspro gauges, factory tach option, Lear cap, DC crankdown tire carrier
Hadley air horns, Stealhorse leather seats, e-mail (home): <bombedcummins@sympatico. ca> (link at top is work address)
 
Status
Not open for further replies.
Back
Top