How Did the RMTDR dyno day go?

[azcummins]

Well... ... Who has the numbers?

 

[mlockner]

az,

I don't know who has the numbers. Mine were 345hp and 885 torque. My truck was number one Dodge. There was a stock Duramax and a Ford on propane there also. The propaned Ford beat me on torque but not horse power. There were at least 15 trucks that ran. Many Thanks to Colorado Diesel for hosting the Dyno runs and to Barry and the TDR for setting this up. Where were the guys from up north in CO. ??? There was a truck from Iowa and Florida there, a few 03's "one with an EZ he was testing". We will see you next weekend in Ft. Collins if the weather is good. Could you post specific directions how to get to the PFI location or send me a PM with them, I would appreciate it.

Mike L.

 

[DHess]

Mike - pulled this from one of mgoncalves posts on the other thread - sounds easy to get to:



"The address is 5720 s. Bueno Drive, Fort Collins, CO 80525. The shop is called PFI, they are an import performance shop but they seem pretty respectful of us diesel guys. To get there from I-25, my directions are to take the Harmony road exit (don't know the #) West to College (hwy 287). Then go South on College, until you see Tynan's car dealer ( they have a massive US flag, can't miss it). You'll turn East at the North edge of the dealers lot on Smokey Drive. Then a turn North on Bueno. I'll put up some signs once you're off of College. "



Dave

 

[mlockner]

Dave,

Thanks for your help. How is your new truck running. The 03's were impressive on the dyno.

Mike

 

[DHatfield]

I am the one from Iowa. As far as I know I think mine might of been the highest. My numbers were very low (223HP/660TQ), but the tires kept spinning out on the dyno. Nothing like the smell of burnt rubber on the dyno. I guees I need to get it redynoed somewhere else.

 

[RamThatStroker]

Well guys I just wanted to say thanks and good job to all who put together the dyno event for us. I had a great time and it was cool to meet and associate with other TDR members. With the help of other TDR members I was even able to convince my dad to put his 03' 3500 4x4 6-speed on the dyno. His numbers were 232. 2HP/625TQ, which in my opinion is impressive since his truck is bone stock and only has 2000 miles on it. I can't wait for the next dyno in September because by then hopefully I'll be able to bring my truck in which I plan to heavily modify over the summer and see what she does.



Joe

 

[mgonske]

I'm the one from Florida with the EZ

Finally back from the trip. What a great bunch in RMTDR and at Colorado Diesel! Thanks for putting up with a 'foreigner'



Here are my numbers:



Stock -236 HP, 631 lbs-ft

EZ Level 4-295 HP, 760 lbs-ft

EZ Level 6-307 HP, 854 lbs-ft



It was nice to see the numbers posted by two stock trucks were so consistent--really gives me faith in the pros from Colorado Diesel who ran the dyno. Thanks again to all!