I have a 94 2500 2 W/D 3. 54 gears, automatic. It is stock in all departments except that I did reseat and pin the KDP. It was stalking my engine looking for the proper time to fall into the T/gears. I also have a stock exhaust except with out muffler or cat. I also repaired the cooler lines connectors. My problem is that I pull a 31' Airstream whick I am told weighs in at about 7000# +- and also a 20' car hauler weight dependent on what I have on it. Trailer is 2500# empty and I will at times for short pulls have as much as 9000# pay load on the trailer. I am wanting to get more torque in the 1800--2200 rpm range. I was looking at a fuel plate and retipping the injectors as I have one that is not delivering full power at times. It has a partial miss at full or near full throttle at times. I gathered from some of the posts on the forum that the #6 plate would be near what I want. I do not want to kill the fuel economy. I get N/L millage of 22 MPG at 75 mph now and 19 mpg local. H/W millage with a 5000# trailer at 75 mph is 16. 5 on a 2000 mile trip, Oklahoma to /Chattanooga, Tennessee. What has you experiance been with the plate change? Another thing I have found strange is that the oil in this engine will stay clear for 5000 miles. When I drain it it is still almost as clear as when I put it in. I find this unusual for a diesel. I like it but I believe it is because the truck is lean. I also get no smoke at the exhaust. Any feedback would be helpful.