Here I am

I need a rebuildable 618 or 727 lockup transmission. Know where I can get one?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Preheating system acting funny again....

Any practical ways to improve 1st gen 1 ton brakes?

Status
Not open for further replies.
I'm tired of my 518.

------------------
http://coffeewithJesus. homestead.com/web1.html 89 1-ton, Amsoil System 3000 5-30,K&N air filter, cleaned-up exhaust, Dynomax straight-thru, rebuilt pump, thermostatically controlled twin 14" Permacool electric fans, intercooler), modified 518 OD transmission, Gear vendors OD controler, R-134 refrigernt, louvered front fenders, 93 aftermarket smoothie grille, new Dupont Chromacolor black, black-and-red rubber rubstrip, black headlights, powdercoated bumpers; 78 35'Avion, 93 Lance 900 slide in with generator and power jacks. To see my truck, Click on: <A HREF="http://albums.photopoint.com/j/AlbumIndex?u=1169022&a=10097213

Jesus" TARGET=_blank>http://albums.photopoint.com/j/AlbumIndex?u=1169022&a=10097213

Jesus</A> saves!
 
Last edited by a moderator:
I found mine through mypartshop.com . Search for a 1994 to 1996 auto with 360-6(Hollander's designation for our beloved Cummins). This site will give you a list of the three nearest salvage yards with the parts in stock. Ended up getting mine out of Kentucky for $1100 including shipping. Shop around though, I found prices as high as $2500(for a used trans??!!!). If you want a 727 with lockup you'll have to have it custom built as Chrysler never built one for the Cummins. Good luck.

------------------
89 w250, 47rh trans, cleaned up exhaust, Dynomax bullet muffer, 3" lift
 
Way back when... Bill & I put a 47RH into a 93 Dodge. You need a bellhousing & Starter from a 94 & newer. You have to move the crossmember back 1 1/2" Shorten the rear drive shaft [lengthen the front if 4x4] move the shift linkage bracket on the frame back about 3/4" & hook up a switch for the lock up converter & enjoy #ad

Make sure you get a trans from a 94 or 95 Diesel. You want the 47RH not the 47RE that comes in a 96 or newer.

------------------
Piers, BD engine R&D
 
If the first Gen truck is a 4x4 will the np205 transfercase fit a 47RH transmission?
Gene
92 350
4x4
 
Status
Not open for further replies.
Back
Top