2nd Gen Non-Engine/Transmission Infinity speakers out... How do I wire the new ones?

[firefighter_2000]

My infinity speakers blew a couple of years back, and I've just not gotten around to fixing/replacing them. They're the infinity speakers with the TEN pin white connector (pictured below). So i buy a set of speakers on ebay with the infinity amps and they have the 4 pin connector. Anyone know if its possible to wire it so the 4 pin speaker will work and also the tweeter work too. Right now with the speaker unplugged the tweeter on the drivers side doesnt work. I plug it back in and the tweeter works. Any help is GREATLY appreciated.



This is the speaker thats blown... with the ten pin connector



#ad




And this is the speaker with the four pin connector that i want to use.



#ad

 

[KHellewell]

Speakers

I too had my speaker go out on a driver door, bought two new 6x9 speakers removed amp from old speaker zip tied to back of new speaker, and put it back in, sounds a lot better than the old one did.