Installing Injecters?

[Rattler]

Hey guys, i know it has been posted before but i need the installation instuctions for a set of injecters. Or even better, someone willing to help.

 

[TERMINATOR]

Installing injectors

I replaced my injectors a while back its not that bad once you get cover off,you will see hold downs for injectors remove one bolt from each side of the hold down you dont have to remove both sides you will see what i mean when you get to it . One side slides under the stud. Loosen all the fuel lines going to head,then you have to remove the blue hold downs that hold the fuel lines in place. Once thats done you will be able to move the lines from the head far enough to remove the fuel tubes that are behind the fuel lines that feed injectors. I used a little pick to grab the tubes you might have a little tough time pulling them out mine were a little tight be carefull with the seals dont rip them make sure you inspect them before you install them back. To remove the injectors i used a bolt and threaded it in to the top of injector i forget thread size too long ago. They are going to be tight coming out you are going to need leverage to pull them out i used 2 snap on pry bars one on each side of bolt and pulled them out no problem be carefull where you put the pry bars when pulling a small block of wood works good. Its easy if you can get your hands on injector puller you wont have to go through all that. Putting the new injectors in i put a little oil on the seals so they slip in better make sure injector feed hole is facing toward the fuel lines when installing. Apply a little downforce on injectors and they should pop in. Install all your tubes and lines dont tighten them until you install your injector hold downs i dont remember the torque specs maybe someone else will help you out with that. Install fuel line hold downs and tighten lines. Install Valve cover. Never had a problem with mine good luck.

 

[Whitmore]

Term, go to Fritz rampage, they have some decent instros there that will help,or head on up to WYO and I will help, you buy the beer Kevin

 

[Tentman]

Just how big a difference is there between the stock injectors and the 275's? The new torque convertor goes in next week and I know after that I'll need more. . .

 

[Evan A. Beck]

275's will give anywhere from 25 to 40 HP. A mild BOMB, but hey--ya gotta start somehwere.

 

[SEmerson]

275's are mild. You will bearly feel a differance.

 

[Whitmore]

the addition of thr 275's on top of my ez were enough to make me say hey south bend my truck is a stud

 

[Rattler]

Hey guys, i went to Fritz page and downloaded the instuctions. Thanks for the help. I don't think i will have any problems now. I ordered a set of injecters and box from Barry in Tx. and now just waiting on them to get here.