Instrument/Dash Bezel Replacement

[WOT]

Does anyone out there sell a replacement dash bezel? I am trying to locate a good place to put three 2-5/8" guages and am thinking about modifying the bezel but would like to get a spare to work on.



Also, does anyone sell a dash mount 3 guage setup in the 2-5/8" variety (only seen 2-1/16" from autometer).



Thanks!

 

[work2muchplay2little]

WOT, no sure if this is what you're looking for... http://216.167.98.200/CoastalData/s...470307&st3=37221425&CATID=1&ObjectGroup_ID=50

 

[WOT]

Those are stick on covers... I am looking for the entire bezel replacement so that I can cut & modify one to fit some guages.

 

[Shovelhead]

Have you checked you friendly neighborhood auto/truck recycling establishment?

(junk yard)

 

[EMDDIESEL]

As for the 2-5/8" gauge pods, they currently dont exsist. Autometer will probably never make them unless enough people want them. I think it also has to do with the space available. The 2-5/8" gauges dont seem much bigger but when you put them side by side and see how much more room they take up, you will see Autometer did not make a pod for them

 

[WOT]

I checked a couple of bone yards in the area-no luck. They said it was a hard item to come by.

I have also made some 2-5/8" gauge templates - they are hard to fit in... I can get them in the hole in front of the shifter (standard) if I remove the little compartment thingy. They would be difficult to see when in gears with the shifter forward.

I guess if I can't find a replacement dash to modify then I will have to go with 2-1/16" guages.

Thanks for the input!