"Lamp out"

[Mark31]

"Lamp out" light came on when applying brakes. Replaced both socket strips with mopar strips and new Sylvania bulbs. "Lamp out" still on. What next?

 

[Tuesdak]

On solid? Check all the bulbs: turn signal headlights on, etc.

 

[B.G. Smith]

Some code/lights will reset after three cycles of start, driving, park etc. If it doesn't reset youo will need a scanner to reset. bg

 

[Crunch]

"Lamp out" light came on when applying brakes. Replaced both socket strips with mopar strips and new Sylvania bulbs. "Lamp out" still on. What next?

Did you verify that it was a brake light that was out? If not, it may have been a turn signal light that burned out. I just replaced my brake lamps a week ago, and the "Lamp out" light went out immediately.

 

[Mark31]

I should have posted "the end" of this earlier. A couple of days later, the high beam went out of a headlight. Replaced them both with Sylvania XtraVision bulbs and that took care of the "lamp out". I lowered them a little bit to make up for aging rear springs. They replaced some Phillips bulbs that were recommended on here. I like these Sylvanias better. Maybe I'm all lit up for the next 7 years!