Engine/Transmission (1994 - 1998) Lets talk nitrous

[BTilson317]

alright so i got DDP 3's and a super phat shaft 62/12 with all the pump mods and afc junk w/ 4 gov. arc flow intake for water meth or nitrous port injection... now i have a 10lb brand new bottle with a 75hp shot for now to test her out... is there anytthing i should know about this before i have some fun and put it on. ?? lol the smoke wont clear out at all on take off. . so would this be safe??...

 

[fest3er]

All I can say is watch your injection timing. NO2 effectively advances injection timing (causes ignition to occur earlier). Ignite too soon and your engine might suffer from exceedingly high cylinder pressures, evidenced by head gasket failure (POP-POP-POPPITY-POP) while accelerating. A small amount of NO2 shouldn't cause problems. But a large amount probably will.

 

[KLockliear]

Don't get on the nitrous until you have at least 15psi and 2200+rpm.

 

[BTilson317]

sounds good thanks ill keep lookin into articles and such

 

[CodySanders]

all i can say is becarefull with the drugs they are addicting and can lead to problems (in both people and trucks)