Here I am

Lift Pump p/n - again

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Request For Gauge Pictures

Flywheel tooth count?

Status
Not open for further replies.
Chuck, sorry I wasn't on earlier to answer that for ya, but I see you figured that out. ;)

If you got the low pressure pump it'll be 15-16 at idle, and depending on mods, 10 or so WOT. That's what mine runs.
 
looks like mine idles around 19-20lbs... cruising at 70 it gets down around 17. 5. stomping it it'll go down to 12 or so. . I hope that's not too much pressure for my VE?. . I also don't have a lot of confidence in the westach guage though. seems not built quite as well as a isspro. might just be reading a little higher than actual... ... .
 
well, it looks as though my gauge/sender might not be working right. installation page says the gauge should read a 2lbs when the key is switched on. . mine pegs down just passed zero. . i checked the grounds and even grounded the thing straight to the battery. no change... .



Guess I'll get a mechanical gauge and test the "actual" pressure. . I'm worried about the seals on my VE... ... .....
 
Last edited:
Status
Not open for further replies.
Back
Top