Engine/Transmission (1998.5 - 2002) Location for fuel pressure diaphragm isolator?

[AGibson]

I purchased new gauges for my 98. 5 and read all the instructions. The suggested installation procedure for the diaphragm isolator states "Install the isolator under the hood at any convenient location. " Does anyone have pictures or ideas where best to mount the isolator?

Thanks!

Alan

 

[Ramafid]

I mounted my isolater on the bracket that the master cylinder mounts to. I just drilled the side of the bracket with self tapping screws and it works great. Good luck.

 

[RHARVEY]

Here is the isolator that I install on my wifes 2000. .

 

[Car_nut57]

We have been putting them on the lip of the batery tray or on the pinch weld on the firewall.

 

[tajensen]

I put mine right ontop of the wheel well inside the engine compartment. This spot made it really easy to tighten the nuts from the other side (above the tires). i removed the plastic part of the wheel well, installed the isolator, and then reinstalled the plastic thing. Looks and performs great.



-Tim

 

[Sixpack]

Here's mine. Located on drivers side firewall.

 

[Sixpack]

A closer look.

 

[kboettcher]

This is what I did with my isolator..... used a greasegun hose from post-filter tapping, into isolator, then ran the small tubing from that to the gauge. I just tye-rapped the isolator to the engine oil dipstick tube. Here is a picture... ... this is my first photo attatchment, so I hope it works.